Simple Wiring

From Lumenlab

This wiring scheme makes use of a dual switch interlock. The interlock makes it impossible to start the lamp without powering on the fan first. You should also let the fan run for about 5 minutes after shutting down the lamp to continue to cool the enclosure. All wire that is near the lamp should be heat resistant and shielded from direct UV. And use an appropriate gauge wire.

YOU ARE WORKING WITH HIGH LEVEL MAINS VOLTAGE. TAKE EVERY PRECAUTION TO AVOID INJURY AND/OR DEATH!

Always unplug, and turn switches off (and remove the fuse) before working with the internal wiring. Also use caution when working with the ballast and LCD power supply, transformers used in these devices are capable of storing very high levels of power that can cause serious injury and/or death! Always follow instructions for ballast wiring, and when in doubt seek advice/help! Lumenlab is NOT responsible for your safety!

---

Continue to Projection Screens or go back to Component Layout.