Lumenlab > Will this monitor work?

mike6789

Dec 24 2005, 01:30 AM

http://www.tigerdirect.com/applications/Se...56141&CatId=164

Does that one have any problems?

Im not 100% sure what an FFC issue is, but I think its when the monitor has a short, complex FFC cable that cant be extended, and therefore you cant mount your boards properly inside the PJ, is that right? If so, why cant I just solder wires onto the end tips of the FFC cable, run those, and solder them on the corresponding points on the board??

Thanks

jonjandran

Dec 24 2005, 02:14 AM

QUOTE (mike6789 @ Dec 23 2005, 08:30 PM)

http://www.tigerdirect.com/applications/Se...56141&CatId=164

Does that one have any problems?

Im not 100% sure what an FFC issue is, but I think its when the monitor has a short, complex FFC cable that cant be extended, and therefore you cant mount your boards properly inside the PJ, is that right? If so, why cant I just solder wires onto the end tips of the FFC cable, run those, and solder them on the corresponding points on the board??

Thanks

Because some ffc's are so small and have very close pins. Very hard to do and it's much easier to order an extension from LL and have it in 3-4 days.

mike6789

Dec 25 2005, 12:04 AM

QUOTE (jonjandran @ Dec 24 2005, 02:14 AM)

Because some ffc's are so small and have very close pins. Very hard to do and it's much easier to order an extension from LL and have it in 3-4 days.

haha yea but what if its like a 26 pin to 30 pin cable?