While testing my lenses for alignment, I fired up the bulb without the LCD in. When I did this, I noticed moire lines on the wall. I am not sure if this should always happen when the LCD is out of the box, or if I should adjust the lenses before I place it in the box. My lenses are set at the standard measurement, if not slightly more. Thanks!

Almost there. Hopefully everything will work correctly!!!

Can you show a pic?

I have not taken one yet, and don ot have it set up for that right now. They are the typical moire lines that will happen with the LCD in if the fresnels are too close.

This sounds normal. I think what is happening is the lens is focused on one of the fresnels instead of inbetween them where the LCD will be placed. Once you put the LCD in and focus on it, you shouldn't see the moire lines anymoire.

By the way, how about using this for your avatar:

Click to view attachment