I have a Channel Master 3671 VHF/UHF Antenna. I have a problem pulling in WCPO in Cincinnati a Straight Line to the Towers would be about 70 Miles. It should pull in 100 Miles VHF and 60 Miles UHF. WCPO is 9 Analog and 10 Digital is there anyway I can make a Super Antenna Especially for 9 and 10 to reach out and pull those 2 frequencies I would like to build it with a 2"x4"x10' or 12' and using the curtain rod method cutting them to length and using screws ,washers and wire to do the zig zag or whatever method used to connect the elements can I use the front half for channel 9 (5 to 6 ft) and the back half for channel 10 (5 to 6 ft) I can go by the pictures posted back a few pages back I need to know how far to put each element behind each other on the exact spacing. IF this takes care of Analog 9 and Digital 10. I want to make another SUPER VHF for longer Mileage wise. Would it be capable to make a VHF to pull in upto 150 Miles it will probably have to be 20 ft long for that range tho. I want to make a Super UHF to pull in this Distance. I want to try to get Columbus Ohio maybe Indy and Louisville If needed. I do not care for Huntington/Charleston WVA. but if needed to rotate it that way I can if needed. My old Antenna was blown down last November due to a Wind Storm I had the CM 3671 for a Month or so before the old one was blown over Old one was up about 40-45 ft. i had it where I could adjust it up and down. I did not get it down before the wind hit to the lower level it was not guyed on the top due to me adjusting it up and down to find the sweet spot I wanted to find for signals. I was planning on guying it after I found the sweet spot. I need to rent a lift or find someone that has a Bucket Truck to help me get up to go higher I want to put 1 or 2 more 10 ft. Tower Sections in to get me up to 50 ft. Currently the top of the tower is about 27 ft high. I have heavy duty wire Thick Guage Wire (can't recall exact guage) but is heavier than any Guy wire to guy antennas. I am going to Guy the tower on each side in about 3 or 4 different spots and guy the pole under the Antenna and abouve the rotor. Enough about that. Can I make a SuperChannel 9/10 Antenna. A super VHF and a Super UHF Antenna to gain extra Mileage and reach out to pick up those problem signals where it wants to tile up. Usually in previous times I could only pull in WCPO upto 10am after that it is usually pretty hard to pull in or it would tile up alot. I do have a hill to contend with I think at the current level I am clearing the top of it but I need to go higher. That was possible on the Adjustable way I had it. I need to rent a lift when it dries up so I can at least get back up close to 50 ft again.