Hey there, I'd like to finish at least wiring in the projector tonight, and need help with the wiring, here's the diagram i'll be using




as you can see it'll run through a switch, and I'd like to tie in my LCD to this as well. the LCD has a 2 prong connector that runs through an inverter, where should I run the wires too to tie it into this switch?

also I can guess that I'll probably need a fuse, where should I add the fuse at? and if so how much of one?


THAAANKK YOU!!!

Pardon the paint additions !!



Will work OK, I'd use a 3A Fuse.

awesome! and good use of paint! just got to pick up a 3A fuse now! thank you very very much~!

The 3A is a guess, work out the actual value with: P=VI

or in this case I = P / V

I is current in Amps ( the fuse value) round up the answer to the nearest rated fuse.
P is power in Watts, will be rated on the side of your monitor PSU
V is voltage in Volts, if in the USA this will be 120v