I know some of the measurments are a bit odd but it looks to me like this should work fine other than my having to tweak a bit here and there.
The ballast will be behind the mirror. I hope to put the wireing and etc there as well.
This was a scale drawing I did @ work on my markerboard lol
seen those and that is what I was basing my design off of, but obviously with a few modifications to use my existing LCD sled and fresnel frames (and place the components inside the box behind the mirror). I know however I have to flip the LCD around though. My main concern was with the light cone / path from the fresnels to the mirror. I will be using a 10 x 8 3/8" FS mirror so will be cutting it close. I also wanted the front lens to be a bit higher as then lest keystone adjustment would be needed since I am putting this on the floor.
Been 10 years since I have had to draw something up and design it like this and actually think lol (man even had to look up some old equasions like to find the measurements of a triangle and etc lol). AutoCAD would have been soooo handy lol even though its been years since I had used it
Been 10 years since I have had to draw something up and design it like this and actually think lol (man even had to look up some old equasions like to find the measurements of a triangle and etc lol). AutoCAD would have been soooo handy lol even though its been years since I had used it
This is a "lo-fi" version of our main content. To view the full version with more information, formatting and images, please click here.