jfuller_law
Nov 17 2006, 09:48 PM
Materials List
-------------------------
(1) HP L1740 LCD 1280 X 1024 Max, Contrast 500:1, Refresh Rate: 13ms, Dot Pitch: 0.264 mm
(1) LL - 220 Rear Fresnel
(1) LL - 650 Front Fresnel
(1) UV Lexan Sheet from Home Depot
(4) 5/16 Full Thread Rods +washers +nuts (purchased from Lowes) $11.00 referenced from 'Punisher'
(1) Can High Heat Paint (purchased from Lowes)
(1) Indoor/Outdoor Therm. (purchased from Lowes) sku#____ $7.99 referenced from 'SculptorM'
(1) Thermostat (purchased at Home Depot) sku# 144967 $ referenced from 'Tameone'
Time Worked on Project: 30 minutes
-------------------------------------------
Stripping the LCD Panel: 30 minutes
AG Film Removal:
Building the Frames for the LCD and Fresnels:
jfuller_law
Nov 17 2006, 10:05 PM
Started stripping the monitor this week. See pics below...
Had no problems stripping this monitor.
Decided to wait until I got further along to perform the AG removal. Worried about scratching the LCD.
Total Strip Time approximately 30 minutes.
Click to view attachmentClick to view attachment
jfuller_law
Nov 17 2006, 10:08 PM
jfuller_law
Nov 17 2006, 10:12 PM
Flipped it over and started working on the backside.
Click to view attachment
jfuller_law
Nov 17 2006, 10:13 PM
Removed the cover to the PS and Video Board.
Click to view attachment
jfuller_law
Nov 17 2006, 10:15 PM
Tooks pics of connectors.
Click to view attachment
jfuller_law
Nov 17 2006, 10:16 PM
Removed PS board and Video.
Click to view attachment
jfuller_law
Nov 17 2006, 10:24 PM
Close up of back panel with boards removed.
Click to view attachment
jfuller_law
Nov 17 2006, 10:24 PM
Back panel removed with controls connector.
Click to view attachment
jfuller_law
Nov 17 2006, 10:26 PM
Back to stripping the back panel.
Click to view attachment
jfuller_law
Nov 17 2006, 10:27 PM
Removed the FCC connector and remove the access panel to the LCD ribbon connector.
Click to view attachment
jfuller_law
Nov 17 2006, 10:28 PM
Removed access panel to the LCD ribbon connector.
jfuller_law
Nov 17 2006, 10:28 PM
Removed back panel and exposed the LCD itself.
Click to view attachment
jfuller_law
Nov 17 2006, 10:30 PM
Removed the 3 different films from the underside of the LCD and backlit mechanism.
Click to view attachment
jfuller_law
Nov 17 2006, 10:32 PM
Pic of the backlit.
Click to view attachmentThe LCD strip is complete, except for the AG removal.
On to building the frames for the LCD and the fresnels.
I will be using the LL - 220 and 650 fresnels.
jfuller_law
Nov 17 2006, 10:33 PM
One last pic of the stripped LCD panel.
Click to view attachment